Programming instructions

Sewing-length range exceeded

Incorrect insertion position (side seam only)

The side-seam insertion range is marked on the clamp strips with two

red flags.

–

Turn the main switch off and on again.

Upper part not engaged

If the upper part of the machine has not engaged properly after being

swivelled up or down, the message "upper part not engaged" appears.

Sewing is blocked.

–

Engage the upper part.

–

Press Enter to clear the message.

The sewing machine is ready for operation.

Folding table not engaged and folding table not retracted

If the folding table has not been retracted to its starting position, the

message "folding table not retracted" appears when the sewing

machine is switched on.

–

Retract the folding table as far as it will go.

–

Press Enter to clear the message.

The sewing machine is ready for operation.

Flash full

The internal flash memory is full. It can be cleared by transferring

seam programs first to a memory card, then back into the controller.

–

Save programs to a memory card.

See section 3.1

Enter rail code

example:

X = 91 , Y = 11

FLASH

FULL