Programming instructions

A. Appendix
A.1 safety messages
During operation the sewing machine is constantly interrogated by the
controller about matters with safety implications. If any response is
not satisfactory, a safety message appears in the display.
Slide-plate catch
The slide-plate catch has been opened.
–
Engage the slide plate.
The message disappears.
Protective hood not down
The protective hood has been raised.
–
Lower the protective hood.
The message disappears.
Protective hood not in centre position
The protective hood has not been raised.
–
Raise the protective hood to its centre position.
The message disappears.
Vertical cutter on/off
The vertical cutter must be switched on so that the jacket-breast-dart
sewing cycle can begin.
–
Switch on the vertical cutter.
The message disappears.
Vertical cutter off
The vertical cutter must be switched off so that the side-seam sewing
cycle can begin.
–
Switch off the vertical cutter.
The message disappears.
Compressed-air monitor
If the air pressure is lower than it should be before sewing begins, the
message "compressed-air monitor" appears.
Sewing is blocked.
–
Check the compressed-air supply.
Press Enter to clear the message.
The sewing machine is ready for operation.
50