Programming instructions

6.4.5 Selecting the transmitter elements

This program checks the function of the transmitter elements.

Caution: danger of injury

Do not reach into the machine while the transmitter elements are

being function-tested.

–

Press the Enter key to run the test program.

–

Select distributor Y or YC.

–

Enter the code number of the required transmitter element.

The abbreviated designations in the wiring diagram are used as

code numbers (see following table).

–

The display shows the switch status (ON/OFF) of the selected

transmitter element.

–

Press the F4 function key to switch the selected transmitter

element ON and OFF.

–

Press the F1 function key to leave the test program.

CAN node smoother

transmitter function

element

YC101 smoother to the left

YC102 smoother to the right

YC103 lower smoother

YC104 raise smoother

YC105 open clamp 2

YC106 close clamp 2

YC107 open clamp 1

YC108 close clamp 1