Programming instructions

6.3.2 Sewing-foot setting
This program is used to run the "sewing-foot setting" test.
The test takes place in stages that are initiated individually by
operating the foot pedal. The process can be terminated at any time
by pressing the STOP key.
–
Press the Enter key to run the test program.
–
Operate the foot pedal.
The guide rail descends.
–
Operate the foot pedal.
The sewing foot and fabric-thickness cylinders descend.
–
Operate the foot pedal.
The sewing foot is locked.
–
Turn the handwheel to bring the sewing foot to bottom dead centre.
At its lowest point the locked sewing foot must be at a distance of
0.2 mm from the stitch plate.
–
Measure the distance between the sewing foot and the stitch plate.
–
Turn the handwheel to return the sewing foot to top dead centre.
–
Operate the foot pedal.
The sewing foot and fabric-thickness cylinder ascend.
The material-guide rail rises.
6.3.3 Testing the step drive
This program tests the function of the stepper motors.
When the program is run the X axle moves to its maximum possible
position and returns to its basic position. The Y axle then does the
same.
The cycle is repeated until the user stops it.
CAUTION:
Remove the vertical cutter before testing the step drives (see
Operating instructions, section 4.8.2).
–
Press the Enter key to run the test program.
–
Press the "Start" key.
The program begins.
–
Press the ”Stop” key.
The test cycle is interrupted.
–
Press the F1 function key to leave the test program.
6.3.4 Testing the stacker
This program tests the stacker process.
NB:
For this test the stacker must be switched on in the "Global
parameters" menu (stacker on).
–
Press the Enter key.
A complete stacker process is executed.
38