Programming instructions

4-26

1.7.11 Setting of edge cutter speed

With this parameter, you have the option to set the speed of the edge

cutter.

If the parameter is set to “0", the edge cutter speed saved in the

transponder is applied.

The speed can be adjusted in steps of 200 r.p.m.

Operating steps

–

Select menu with the “ ” or “ ” key.

–

Press the “OK” key.

The selected settings are displayed.

–

Set the desired speed with the “á”or“â” key.

–

Press the “OK” key.

The set value is saved.

–

Press the “ESC” key.

The changes are cancelled.

1.7.12 Setting of suction delay

With this parameter, you have the option to adjust the delay until the

suction unit is switched on.

If the parameter is set to “0", the switching delay saved in the

transponder is applied.

The switching delay is set in % values of the material clamp seam

length.

Operating steps

–

Select menu with the “ ” or “ ” key.

–

Press the “OK” key.

The selected setting are displayed.

–

Set the desired switch-on delay with the “á”or“â” key.

–

Press the “OK” key.

The set value is saved.

Press the “ESC” key.

The changes are cancelled.