Operating instructions

5.15 Ribbon binder (class 69-373)

Two ribbon-binder sets are available for subclass

69-373

sewing attachment E4: for narrow bindings

sewing attachment E5: for broad bindings

Caution: danger of injury

Turn off the main switch.

The ribbon band may only be inserted with the sewing

machine switched off.

Inserting the ribbon band

–

Place the ribbon band on the lower pulley of the reel holder 3.

–

Place upper pulley and pressure spring 2 on reel holder 3.

–

Screw knurled nut 1 onto reel holder 3.

The ribbon band should be kept under slight pressure.

–

Slightly raise the arm cover 6 and swivel it forwards (towards the operating side).

–

Pass the ribbon band between the guide pins 5, through the ribbon guide 4, into

the ribbon binder 8 and under the sewing feet.

–

Swivel the arm cover 6 back into place.

Adjusting the distance of the seam from the ribbon edge

–

Undo screws 7.

–

Adjust the distance of the seam from the ribbon edge as required by moving the

ribbon binder 8.

–

Tighten screws 7.

4 5 6