Operating instructions

5.5 Winding on the looper thread
Caution: danger of injury
Turn off the main switch.
The looper thread may be threaded for winding on only
when the sewing machine is switched off.
–
When winding on for sewing with no underlay material:
arrest the sewing feet in the up position (see chapter 5.10).
–
Thread looper thread as shown in the upper illustration.
–
Wind about 5 coils of looper thread clockwise onto the bobbin core.
–
Place bobbin 3 on bobbin-winder shaft 5.
–
Swivel bobbin-winder lever 4 against the bobbin.
The bobbin-winder wheel 2 is pressed against the V-belt.
–
Adjust tension 1.
The looper thread should be wound on with minimal tension.
–
Sew.
The bobbin-winder lever 4 terminates the process as soon as the bobbin is full.
5.6 Fitting the looper-thread bobbin
Caution - danger of injury
Turn off the main switch.
The looper-thread bobbin may only be changed with the
sewing machine switched off.
Removing empty looper-thread bobbin
–
Turn handwheel until the needle bar reaches its highest position.
–
Pull off cap 6 in the direction of the arrow.
–
Raise bobbin-housing flap 8.
–
Remove top 7 of bobbin housing with bobbin.
–
Remove empty bobbin from top 7 of bobbin housing.
Threading looper thread
–
Place full bobbin 11 in top 7 of bobbin housing:
when the thread is wound off the bobbin 11 must rotate in the direction of the arrow.
–
Draw looper thread down through slit 10 under tensioning spring 9. Pull about 8
cm of looper thread out of the top 7 of the bobbin housing.
–
Replace top 7 of bobbin housing.
–
Close bobbin-housing flap 8.
15