Operating instructions

Controller with the OP7000 control panel
Operating Instructions 650-16 - 01.0 - 06/201496
Setting the curve support
The following table lists the symbols and buttons for manually
setting the curve support.
The default setting is a value of 2.
1. Input the curve support using the buttons 1 to 6.
MAN mode Other program parameters
After the Other program parameters button has been pressed,
an overview of all the available parameters is displayed.
Figure 65: Other program parameters in MAN mode
Symbols/buttons Meaning
Inputting the curve support
The curve support is displayed by a button
highlighted in red.