Operating instructions

Controller with the OP7000 control panel
Operating Instructions 650-16 - 01.0 - 06/201494
8.5.1 Parameters that can be set in MAN mode
The following table lists the parameters that can be set in MAN
programming mode.
1. Press the desired button.
 The user interface for setting the parameter is displayed.
For some parameters the setting is more than just a numerical
value. These parameters are described below.
Symbols Meaning
Setting the fullness,  page 95
setting the curve support.
Other program parameters in manual mode MAN,
 page 96
Inputting the needle thread tension
Inputting the stitch length in mm