Operating instructions

Controller with the OP7000 control panel
Operating Instructions 650-16 - 01.0 - 06/201488
8.2 Switching the sewing machine on
1. Switch the main switch on.
 The OP7000 control panel is switched on.
• The machine class is shown on the left of the display, the
firmware is shown on the right.
• The machine performs a reference run.
• The control panel starts in the mode that was active when
it was switched off - MAN or AUTO.
8.3 Controller operating modes
The controller has four operating modes available:
• Manual mode MAN
Manual mode is the simplest operating mode.
There are no sewing programs and no inputs for individual
sewing steps.
Changes to the fullness, stitch length, thread tension, curve
support and also the activation of other functions are imple-
mented immediately.
Thus all the major sewing parameters can be changed man-
ually during the sewing process.
• Automatic mode AUTO
Automatic mode allows sewing programs to be executed.
The seams are divided into individual sections within the sew-
ing programs. Each step is assigned its own individual sew-
ing parameters such as fullness etc.
• Programming mode
In Programming mode, new seam programs can be created
(PROGRAMMING), existing seam programs can be edited,
deleted, copied and mirrored (EDIT) and also optimized
(Length Correction).