Operating instructions

Controller with the OP3000 control panel
Operating Instructions 650-16 - 01.0 - 06/2014 83
 The following display appears, with “P” flashing:
Figure 54: Inputting parameters when creating a new program
The rest of the procedure is as described in the section<reference>
Quick programming,  7.6 Quick programming, page 75.
6. Select whether progression to the individual steps to be pro-
grammed should be by using the knee switch or by automatic
progression.
7. Press the key.
Once the creation of the program is complete and the “S” key has
been pressed or after the thread cutoff has been entered, the
following query window appears:
Figure 55: Query window after creation of a program
8. Select whether
• the sleeve side that was programmed should be mirrored
• the sleeve side that was programmed should not be mir-
rored
• the teach-in for the 2nd sleeve side should be opened.