Operating instructions

Controller with the OP3000 control panel
Operating Instructions 650-16 - 01.0 - 06/2014 79
6. Sew the overlap.
7. Push the pedal fully back.
 The sleeve that was created is mirrored, depending on the
settings at the technician level.
The machine switches to Automatic mode.
The program that was just created is selected.
Figure 49: Displaying the newly created program
7.7 Edit mode
Edit mode allows existing programs to be edited or deleted.
Programming mode should be used to create new programs,
 7.8 Programming mode, page 82.
1. In Automatic mode, press the “P” key.
 The controller switches to Edit mode.
The program previously selected can now be edited.
The following information is shown on the display,
the “P” in the program number field flashes:
Figure 50: Display in Edit mode
1. Use / to select the program to be edited, the sleeve side
and the step; and use 
/ to deselect them.
The step to be edited can also be selected using the knee
switch.
 The selected step is shown bold in the program bar.
2. Use 
/ to select the parameter to the changed for the
respective step, and use 
/ to change it.