Operating instructions

Controller with the OP3000 control panel
Operating Instructions 650-16 - 01.0 - 06/201478
Figure 47: Displaying the newly created program
7.6.2 Creating a program by sewing the seam
1. Insert the material to be sewn.
2. Input the parameters for the 1st step (fullness, stitch length,
thread tension and curve support).
3. Sew the first step.
4. Operate the knee switch.
 The program switches to the next step.
Cancel with ESC
Before the “S” key is pressed, program creation can be canceled
at any time by pressing the “ESC” key.
If a section of seam has already been sewn the program will have
been saved and must if necessary be deleted,  7.8.3 Deleting
a program, page 85.
Once all steps are complete:
5. Press the “S” key.
 The program is saved.
The following display appears:
Figure 48: Display after creating a program by sewing the seam