Operating instructions

Controller with the OP3000 control panel
Operating Instructions 650-16 - 01.0 - 06/201476
Figure 46: Quick programming display
The following table shows the individual symbols in the display
and the functions of the keys on the control panel.
Symbol Meaning
Automatic step progression on/off
• Press the upper softkey
Activates / deactivates automatic step progression for
the current step.
Current program to be created
Current sleeve side to be created
(pre-set at the technician level)
Current step
• Use
/ to select the “Step” parameter.
• Use /to switch to the next/previous step.
• Press the “OK” key to edit other parameters for the
step,  7.7 Edit mode, page 79.
Fullness
Value range: -6 to 16
• Use the keys “0” to “16” to select the desired value.
Or:
• Use the second pedal to select the fullness, if fitted.
• Use the “+/-” key to select upper (+) or lower (-) full-
ness.
Stitch length for the current step
Value range: 1.0 to 5.5 mm
• Use
/ to select the “Stitch length” parameter.
• Use / to change the stitch length.