Operating instructions

Controller with the OP3000 control panel
Operating Instructions 650-16 - 01.0 - 06/201474
Completed steps are shown fully in bold.
Figure 43: Completed step
The following table lists the functions that can be performed in the
course of the seam.
7.5.3 Canceling the program
1. Cut off (push the pedal fully back).
2. Press the “ESC” key.
Key/Pedal Function
+/-
and
0 - 16
Temporary correction of the fullness value
(valid only for the current step)
2nd pedal
(optional)
Temporary correction of the fullness value or the
curve support (depending on the setting in the
technician level)
(valid only for the current step)
Knee switch Next program step
/
3
Stop forward/back or to the start of the step
Switch the sleeve side (if programmed) in the
1st step at the start of the step
/
Correction of the thread tension
The value is saved.
ESC, P, F, S,
OK
No function assigned
Pedal halfway
back
Raise the presser foot
Pedal fully
back
Cut off the thread
The program remains stopped at the cutoff point.
Lower softkey Softkey menu
 7.4 Manual mode, page 66