Operating instructions

Installation

Operating Instructions 650-16 - 01.0 - 06/201450

Steps

1. Lay the cables to the control cabinet and bundle them together

with cable ties.

2. Plug the motor cables to the corresponding plugs on the con-

nection side (2).

3. Plug the other cables to the corresponding plugs on the con-

nection side (1).

4. Connect the LED light to the transformer,  6.9.14 Connect-

ing the LED sewing light, page 60.

6.9.4 Connecting the cables for the additional

controller

Figure 23: Connecting the cables for the additional controller

Steps

1. Connect the 15-pin plug to the correspondingly marked con-

nector on the side of the control cabinet (2), as shown in

 6.9.3 Connecting the cables to the upper part, page 49.

2. Lay the cable (1) for the stepper motor in the underside of the

casing (2) and plug it into the connection plug.

Danger of life-threatening electric shock

Disconnect the power plug before connecting the

cables to the additional controller.

Make sure the machine cannot be accidentally

switched back on.

DANGER

(1) - Cable (2) - Underside of the casing