Operating instructions

Installation
Operating Instructions 650-16 - 01.0 - 06/201444
Important: The unwinding bracket must be vertically above
the thread reel holders.
6.6 Completing the table top
Figure 18: Completing the table top
Steps
1. Insert the oblique fittings (5).
2. Insert the rubber corners (1) into the table top.
3. Using 4.5 x 15 (4x) screws, screw on the hinge mountings (3).
4. Using 4.5 x 55 (8x) screws, screw the edge strips (4) to the
table top.
5. Insert the upper part support (2).
(1) - Rubber corners
(2) - Upper part support
(3) - Hinge mountings
(4) - Edge strips
(5) - Oblique fittings
1
2
3
4
5