Operating instructions

Installation

Operating Instructions 650-16 - 01.0 - 06/2014 43

6.5 Attaching the table top and pedals to the

frame

Figure 17: Attaching the table top and aligning the pedals

Steps

1. Using wood screws (6 x 30), attach the frame (4) to the table

top (2). Drill pilot holes for the wood screws.

2. Use the center marks to position the pilot holes.

3. Turn the frame (4) the right way up.

4. Align the pedals.

5. For ergonomic reasons, align the pedals laterally so that the

center of the main pedal (6) is directly beneath the needle.

The frame brace (3) is provided with slotted holes to allow

alignment of the pedal.

6. Loosen the screws (8).

7. Adjust the height of the pedal rodding so that in the home

position the pedal slope is about 10°.

The lever (5) on the setpoint transducer can be adjusted to suit.

8. Tighten the screws (8).

9. Insert the thread reel holder (1) into the hole in the table top,

and secure it with a nut and washer.

10. Fit and align the thread reel holders and unwinding bracket.

(1) - Thread reel

holder

(2) - Table top

(3) - Frame brace

(4) - Frame

(5) - Lever

(6) - Main pedal

(7) - Additional pedal

(8) - Screws