Operating instructions

Installation
Operating Instructions 650-16 - 01.0 - 06/201442
6.4 Pre-assembling the table top
Figure 16: Pre-assembling the table top
Steps
1. Use the table top (1).
2. Screw on the drawer (2) and its brackets
(chipboard screws 3.5 x 17).
3. Screw on the knee switch (3).
4. Screw on the sewing light transformer (4).
5. Screw on the main switch (5)
(chipboard screws 5 x 30).
6. Screw on the cable duct (6) (40 x 40 x 200 mm long)
(chipboard screws 3.5 x 17).
7. Screw on the strain relief (7)
(chipboard screws 3.5 x 17).
8. Screw on the additional controller (8)
(chipboard screws 5 x 30).
9. Screw on the DAC motor controller incl. protective plate (9)
(chipboard screws 5 x 30).
10. Screw on the cable duct (40 x 40 x 250 mm long) (10)
(chipboard screws 3.5 x 17).
11. Fit the electric cables,  6.9 Electrical connection, page 47.
Larger scale diagrams can be found at the end of the manual,
 10 Appendix, page 127.
1
2
3
8
45
6
7
9
10