Operating instructions

Controller with the OP7000 control panel
Operating Instructions 650-16 - 01.0 - 06/2014116
Parameters that can be set
The following table describes the parameters that can be set in
programming mode PROGRAMMING.
Symbols Meaning
Input the program name.
There is only one display in the
PROGRAMMING mode. A new program is
automatically assigned the next free
program slot.
Select the right or left piece to be sewn
Set the sewing material size,
 page 117
Other program parameters in programming
mode PROGRAMMING,
 page 119
Set the fullness in the current sewing step,
 page 118
Set the curve support in the current sewing
step
Set the needle thread tension in the current
sewing step
Set the stitch length in mm in the current
sewing step
Switch the seam length measurement in
the current sewing step on or off
Other sewing step parameters in
programming mode PROGRAMMING,
 page 120