Operating instructions

Controller with the OP7000 control panel
Operating Instructions 650-16 - 01.0 - 06/2014114
Figure 79: Programming mode progress PROGRAMMING
6. Repeat step 2 until all the sewing steps have been pro-
grammed.
7. Press the END button or cut off the threads.
 There are three variants for the program response - depend-
ing on the user's input method:
8. If the threads were not cut off after sewing, a message appears.
Cut off the threads.
 The message is cleared.
Variant Program display
The last programmed sewing step was sewn
but not cut off, then ended with END.
continue with step 8
The last programmed sewing step was sewn
and threads cut off.
continue with step 9
All sewing steps were input manually and
ended with END.
continue with step 9