Operating instructions

Controller with the OP7000 control panel
Operating Instructions 650-16 - 01.0 - 06/2014108
8.7.1 Editing existing programs (EDIT)
The following table lists the parameters that can be edited in EDIT
programming mode.
Symbols Meaning
Changing the program name
There is only one display in the EDIT
mode. A new program is automatically
assigned the next free program slot.
Select the right or left piece to be sewn
Set the sewing material size,  page 109
Other program parameters in EDIT
programming mode,
 page 111
Set the fullness in the current sewing step,
 page 118
Set the curve support in the current sewing
step
Set the needle thread tension in the current
sewing step
Set the stitch length in mm in the current
sewing step
Switch the seam length measurement in
the current sewing step on or off
Other sewing step parameters in EDIT
programming mode,
 page 112