Operating instructions

Controller with the OP7000 control panel
Operating Instructions 650-16 - 01.0 - 06/2014 107
8.7 Programming mode
Figure 73: Programming mode
Header (1)
The EDIT operating mode is displayed.
Left pane (2)
The graphical representation of the entire seam, divided into the
number of programmed sewing steps, is displayed here.
Middle pane (3)
Existing seam programs can be edited here  page 108. The
number and the name of the selected seam program are dis-
played, together with the symbols for all the parameters that can
be set. The gray fields above the parameter symbols show the
respective current values.
Right pane (4)
Here new seam programs can be created  page 113, existing
seam programs can be deleted  page 121, copied  page 121
and optimized  page 122 (Length Correction).
ཱ
ི
ཱི
཰