Operating instructions

Controller with the OP7000 control panel
Operating Instructions 650-16 - 01.0 - 06/2014106
Changing parameters during the seam
1. Move the pedal to the 0 position.
2. Change the desired parameter on the control panel.
3. Push the pedal forwards and sew.
 The seam will be sewn using the altered parameter value.
Correcting the fullness before or during the seam
1. Move the pedal to the 0 position.
2. Change the fullness correction using the buttons + F% or - F%.
3. Push the pedal forwards and sew.
 The changed fullness value is applied and displayed.
Cancel the seam program
1. Push the pedal fully back.
 The seam program is canceled.