Operating instructions

Controller with the OP7000 control panel
Operating Instructions 650-16 - 01.0 - 06/2014 103
2. If a higher or lower degree of fullness is required, use the arrow
keys to display more buttons.
3. Input the fullness using the buttons 0 to 16.
The fullness value remains active until the next sewing step.
AUTO mode Correcting the fullness ratio
The fullness ratio can be set either by the buttons + F% and - F%
or the fullness correction parameter.
Figure 70: Fullness correction parameter in %
1. Input the correction value for the fullness in percent.
Information for inputting numeric values:  page 89.
2. Press the OK button.
 The correction value is saved and the previous user interface
is displayed.
If the correction value is changed in AUTO Automatic mode
it remains active until the controller changes to the next pro-
gram.