Operating instructions

Controller with the OP7000 control panel
Operating Instructions 650-16 - 01.0 - 06/2014102
AUTO mode Temporarily correcting the fullness value until the next
sewing step
Figure 69: Parameter for temporarily correcting the fullness value
Buttons for manually inputting the fullness are displayed in the left
pane.
1. Select the type of fullness.
 The type of fullness selected is displayed in an activated
control field within the symbol.
Symbols/buttons Meaning
Input the fullness
The fullness setting is displayed by a
button highlighted in red.
Select the type of fullness:
• Upper (upper transport)
• Lower (lower transport)
The fullness selected is displayed in an
activated control field.
Display of further buttons for inputting the
fullness. The buttons 0 to 16 are available
for input.