Operating instructions

Controller with the OP7000 control panel
Operating Instructions 650-16 - 01.0 - 06/2014 99
8.6.1 AUTO parameters that can be set
The following table lists the parameters that can be edited in AUTO
programming mode.
1. Press the desired button.
 The user interface for setting the desired parameter is dis-
played.
For some parameters the setting is more than just a numerical
value. These extended parameters are described in detail below.
Symbols Meaning
Program selection,  page 100
Select the right or left piece to be sewn
Set the sewing material size,  page 101
Other program parameters in AUTO
automatic mode,  page 104
Temporarily setting the fullness value until
the next sewing step,
 page 102
Applying a % correction to the fullness
values of all sewing steps,  page 103
Setting the needle thread tension.
If the value is changed in AUTO Automatic
mode it is permanently saved in the
program.
Setting the stitch length in mm.
If the value is changed in AUTO Automatic
mode it is permanently saved in the
program.