Instruction manual

Operating and function sequence:
Sew ing process Operation / explanation
Prior to sew ing
Starting position - Pedal in rest position
- The machine is at a halt.
- Needle up
- Sewing foot in highest position
Position material
for starting the seam. - Place the material under the sewing foot
At the seam start
Sewing
Press the key (bartack/attaching stitches)
of the
operating panel.
LED ON: Function bartack/attaching stitches ON.
LED OFF: Function bartack/attaching stitches OFF.
One stitch basting
with attaching s titches - Prerequisite: on the operating panel
the key has its LED ON
- Prerequisite: on the operating panel
the key (one stitch basting)
has its LED ON
- Push the pedal forwards.
- The machine sews attaching stitches
with the bartack speed
- During the attaching of the material
the machine should be fed slightly.
- After attaching, the machine stops
with the thread lever in upper position with
the thread tension open (even if the pedal is
pressed continuously, only the attaching
stitches will be sewn).
- Each time the pedal is pushed forward,
a single stitch will be sewn no matter
how long the pedal is pushed forward.
It is possible to pull any length of
single stitch.
Disabling the one stitch basting function
is only possible after the thread trimming.
Sewing continuous seam
with attaching s titches - Prerequisite: on the operating panel
the key has its LED ON
- Prerequisite: on the operating panel
th e k e y (one stitch basting)
has its LED OFF
- Push pedal forwards and keep it pushed.
- The machine sews attaching stitches
with the bartack speed, then continues
at the speed of rotation set by the pedal.
- Feed the material manually
20
B
B
B