Instruction manual

7.2.3 Changing the parameter values

For checking purposes or after a reset the parameter values must be

set according to the parameter sheet (Part No. 9800 370001 PB40)

enclosed in the accessories.

If required, the current parameter sheet can be downloaded from the

website of the DÜRKOPP ADLER AG within the download area:

www.duerkopp-adler.com.

The setting of the parameter is described in the manual provided with

thesewingdrive.

8. Sewing

Caution: Danger of injury!

Please proceed very cautiously, due to the high sewing foot stroke

(up to 19,5 mm) and the related increased danger of injury !

This description is based on the following assumptions:

–

The main switch is turned on.

The following functions are set at the operating panel:

–

Initial bartack: 3 preset attaching stitches

–

The needle reverse function is set in the control parameters.

–

The needle position setting is up.

–

The thread trimmer is switched on.

–

The last sewing process was completed with thread cutting.