Instruction manual

7.2.1 Control unit keys (sewing mode)

If the operating panel C300 is connected, the setting done through the

operating panel will have higher priority than settings done on the

control unit.

Switch free sewing**/

tacking / programmed Bartacking seam begin ON/ OFF

seam segment

Programming key Bartacking seam end* ON/OFF

Needle position top / bottom

at machine stop Automatic sewing foot lifting*

after the thread trimming

ON / OFF

Softstart Automatic sewing foot lifting

ON / OFF after machine stop

UP / DOWN

Indicator for the motor ’s Display for the number

sense of rotation of backtack stitches set

Setting the stitch number

(Range 0 - F)

* A = 10 Stitc hes…

* B = 15 Stitches ....

* Function disabled with this machine.

** Essentially the setting “free sewing” will be used with this

machine.