Instruction manual

6.5 Fitting the hook-thread bobbin

Caution: Danger of injury!

Turn off the main switch !

The hook-thread bobbin may only be changed with the machine

switched off.

Remove the empty bobbin

–

Turn the hand wheel, until the needle bar has reached its highest

position.

–

Open the cap 2 on the arm c over.

–

Raise bobbin-housing flap 1.

–

Remove the upper part of the bobbin-housing 3 together with the

bobbin.

–

Remove the empty bobbin from the upper part of the

bobbin-housing 3.

Threading the hook thread

–

Place the full bobbin 4 in the upper part of the bobbin-housing 3.

The bobbin 4 must rotate in the direction of the arrow when the

thread is pulled.

–

Draw the hook thread through the slit 5 under the tension spring 6.

–

Pull approximately 8 cm of the hook thread out of the upper part of

the bobbin housing 3.

–

Replace the upper part of the bobbin housing 3 again.

–

Close the cap 2.

456