Instruction manual

Fix the table extension on the table plate

–

Screw the clamp levers into the thread insert, in order to leave an

interstice of > 4 mm.

–

Shift the table extension w ithout the insert plate but w ith the 4 in a

way that the slits of the 2 brackets at the rear get engaged to the

bolts of the clamp lever.

–

that the into the bores of the table plate. Tighten the winged

screws with washers from underneath the table plate.

–

Put on the insert plate.

–

Shift the table plate in position.

–

Tighten the clamp levers, if necessary adjust the height of the

extension table by screwing/unscrewing the screws of the front

brackets.

5.2 Mounting the pedal extension

Disassemble and preassemble the pedal and its linkage

–

Disassemble the pedal and its linkage from the stand; the original

linkage will no longer be needed.

–

Attach the pedal to the extension bracket (see sketch).

Mounting the pedal extension (see sketch)

–

Fix the extension bracket with the pedal to the stand.

–

Hook the pedal linkage (a longer one) into the pedal and the set

value initiator. Set it to have the proper length.