Instruction manual

5. Mounting the table and pedal extension (optional equipment)

5.1 Mounting the table extension

Mount the table extension according to the sketch below:

Preassembling the bracket

–

Preassemble the bracket according to the sketch on left.

Preassembling the table extension

–

Turn the table p late upside down and put the insert plate into the

cutout provided for it.

–

Fix the blocks (4x) with screws on the position of the magnets of

the table plate cutout.

–

Adjust the blocks vertically so that the insert plate is always seated

in the table plate cutout but is kept tight enough by the magnets.

–

Fix the supports (4x) with screws on the punch-outs of the table

plate back side.

Attention !

The brackets must rest with the outside edge, not with the bending

radius, against the edge of the recess!