Instruction manual

–

Screw on the drawer 4 with the sockets underneath the left half of

thetableplate.

–

Fix the control unit 1 with three woodscrews (5x30) underneath the

right half of the table p late .

–

Screw on the holder for the strain relief of the mains cable

underneath the table plate.

–

Screw the set value initiator 7 onto the mounting bracket (4 screws

M5x10).

–

Fix the bracket with the set value initiator underneath the table

plate with 4 woodscrews (5x30).

–

Screw the cable channel 6 under the table plate.

–

Fix the table plate with woodscrews (6,0x30) on the s tand. The

position of the table plate is indicated by the dimensions given in

the sketch.

–

Assemble the pedal linkage 2

–

Hinge the pedal linkage onto the pedal and the set value initiator of

thesewingdrive.

–

Adjust the height of the pedal linkage by turning the screw so that

the pedal, when released has an inclination of about 10°.

–

Insert the yarn holder 5 into the hole of the table plate.

–

Hammer the machine head support 3 into the hole on the table

plate.