Operating instructions

Contents page:
Preface and general safety instructions
Part 1: Operating Instructions Class 589
1. Product description
1.1 Designated use...................................................5
1.2 Briefdescription..................................................5
1.3 Subclasses.....................................................7
1.4 Product structure..................................................8
2. Technical data ..................................................9
3. Operation
3.1 Needles, yarns and gimps ...........................................10
3.2 Removingandreplacingtheclampplates..................................11
3.3 Changing the needle...............................................12
3.4 Threading the upper thread...........................................13
3.5 Threading the bobbin thread ..........................................14
3.6 Threading the gimp thread (only 589-221000) ...............................15
4. Thread tensions
4.1 Needle- and bobbin-thread tension ......................................16
4.2 Bobbin-thread-tensioning spring........................................17
5. Changing the cutting blocks .........................................18
6. Spreading the workpiece ...........................................19
7. Hand switches ..................................................19
8. Switching on - Switching off - Safe Stop
8.1 Switchingon....................................................20
8.2 Switchingoff....................................................20
8.3 SafeStop .....................................................20
8.4 Switching threading mode on and off .....................................21
9. Controller
9.1 General.......................................................21
9.2 Operatingthecontroller.............................................22
9.3 Changing parameter values ..........................................23
9.3.1 Numericalvalues.................................................23
1