Operating instructions

8. Switching on - Switching off - Safe Stop

8.1 Switching on

–

The sewing-drive switch 1 must be in position 1.

–

Turnonthemainswitch2.

The Dürkopp Adler logo briefly appears.

The opening screen appears.

8.2 Switching off

–

Turn off the main switch 2.

All drives and the controller are immediately disconnected from the

power supply.

8.3 Safe Stop

Before any work is carried out on the machine it must be switched off

or the safe stop mode activated.

Push the pedal back.

–

Turnswitch1toposition“0".

The machine is in safe stop mode.

This message appears, flashing.

The sewing drive is disconnected from the mains.

The buttonhole blade is switched off.

–

To resume the sewing process proceed as follows:

Turnswitch1toposition“1".

After a short pause the machine is again ready for operation. The

sewing process is resumed at the point where firm hold was

activated.

If the symbol appears in reverse, firm hold was switched on before the

pedal was pushed back.

To clear proceed as follows:

–

Turnswitch1toposition“1".

–

Push the pedal back.

–

Turnswitch1toposition“0".

The machine is in safe stop mode.