Operating instructions

T26 (Cutter)
Standard: 1000
Setting range: 0-2000
The buttonhole is not cut open (no contact/no knife/no block)
The interval T26 is run through.
The cutter cylinder is switched back.
T27 (Clamp plate)
Standard: 100
Setting range: 0-300
The clamp is closed
The interval T27 is run through.
The material is spread.
Care must be taken that the clamps are closed first before the material is
spread.
33.16 Setting the Subclasses
The subclass can be set in this menu. With the subclasses 579-112000
and 579-151000, the E-group can also be set. With the subclass
579-141000 the cutting length group can be selected.
The currently selected settings are indicated by a check mark.
ATTENTION!
The subclass, E-group and cutting length group which are set in this
menu must correspond with the machine being used.
–
When you are in the service menu, sequentially select the following
menu items with the arrow keys and the"OK“ key:
- Subclass
The ”Subclasses“ menu appears.
–
Select the subclass of the machine with the arrow keys.
–
Press the “OK” key.
If the E-group or the cutting length group for the subclass must still
be selected, a submenu in which the E-group and/or cutting length
group appears where the selection has to be be done.
- Select the E-group or cutting length group using the arrow keys.
- Press the “OK” key.
–
If sufficient memory is available, the screen beside with the
message: “Change Subclass ?” appears:
If the Subclass should to be changed, strike the “ð” key.
If the Subclass should not be changed, strike the “ï” key.
66