Operating instructions

Correction

Height of the thread catcher and clearance of the thread catcher to

the needle

–

Loosen screws 5 and 6.

–

Adjust the height of thread catcher unit.

The clearance to the needle bar guide must be 2 mm.

–

Tighten screws 5 and 6.

–

Set the clearance to the needle through the stop screw 12.

The clearance from the thread catcher to the needle must be

approx. 7-8 mm (dimension X). The clearance to the needle can in

some cases also deviate slightly from this value.

Lower position of the thread catcher

–

Loosen the lock nut above the knurled screw 8.

–

With the knurled screw 8, set the lower position of the thread

catcher.

–

The clearance between the thread catcher and the material must

be approx. 3 mm.

–

Manually press the thread catcher down and check the position of

the thread catcher.

–

Tighten the lock nut above the knurled screw 8.

Lateral position of the thread catcher

–

Loosen screws 7.

–

Set the lateral clearance of the thread catcher.

–

Tighten screws 7.