Operating instructions

23. Thread Take-up Disk

Rule and Control

–

Insert a positioning pin into the drilled hole 5 of the sewing machine

and arrest the sewing machine in the stake-out position. The looper

support must be in the left end position thereby.

–

Insert a pin (2 mm diameter) or the shank of the needle through the

drilled hole 2 in the thread take-up disk.

–

The pin must touch on the right side of the thread guide 1.

Caution Risk of Injury!

Set the thread take-up disk only in the “Safe Stop” position or with the

machine turned off.

Correction

–

Loosen screws 3 and 4 on the toothed belt sprocket.

–

Turn the thread take-up disk so that the rule is fulfilled.

–

Tighten screws 3 and 4.