Operating instructions

13.3 Cutting Block Setting

Caution Risk of Injury!

Set the cutting block only in the “Safe Stop” position or with the

machine turned off.

Rule and Control

The cutting block must lie parallel to the cutting knife.

Correction

–

Loosen screw 1.

–

Turn cutting block 2 with the guide.

–

Tighten screw 1.

13.4 Cutting Pressure

Rule and Control

In order that all components be subjected to minimal stress and to

increase the idle period of the cutting knife, the cutting pressure can be

set.

Dependent on the sewing material and material thickness, the cutting

pressure should be set as low as possible. It must be set strong

enough so that the material is still securely cut. The pressure is set at

4 bar at the factory.

Correction

–

Set the desired pressure with the pressure regulator 3.