Operating instructions

12.2 Wide Seam Width

Caution Risk of Injury!

Set the stitch pattern only in the “Safe Stop” position or with the

machine turned off.

Rule and Control

–

Turn the handwheel so that two screws are visible on the cam.

Loosen screws 4 and 5 by one to two turns.

–

Turn the handwheel so that three screws are visible on the cam.

Screw screws 1 and 2 in as far as possible.

–

Tighten screws 4 and 5.

–

At the display of the main menu, press the “F” key.

–

With the arrow keys, set code “25483“.

–

Select the menu items “Configuration”, “Machine” and “Covering

Stitch” in this order and confirm with the OK key.

–

There must be a “B” for wide behind the menu item. If there is

instead a “S” for narrow, change the setting with the arrow keys

and confirm with the OK key.

–

Exit the service menu by repeated pressing of the “ESC”key.

ATTENTION !

After the change of the seam width, the looping stroke (see Chapter

Looping Stroke) must be set anew.