Operating instructions

5.6 Placing and tensioning the V-belt

–

Remove the handwheel and the housing cover from the machine

head.

–

Remove the skip guard

–

Place the V-belt

onto its pulley

and pass it down through the

cutout in the table top.

–

Install again the skip guard

–

Remove the V-belt covering from the sewing drive.

–

Loosen the motor fastening nuts

and place the V-belt

onto its

pulley

on the sewing drive.

–

By swinging the entire sewing motor, adjust the tension of the

V-belt so that it can be lowered in its middle

about 10 mm

when

exerting a slight pressure.

–

Tighten the nuts

–

Fit the V-belt covering on the sewing motor as well as the housing

cover and the handwheel on the machine head.