Operating instructions

5.4 Adjusting and connecting the pedal
Stand set for longitudinal installation and stand set for
transversal installation
–
Adjust the pedal
1
on the stand strut
2
sideways so that the middle
of the pedal stands more or less under the middle of the needle.
–
Screw the pedal
1
to the stand strut.
Stand set for transversal/longitudinal operation
When using this stand set, the pedal can be adapted to the different
working positions as follows:
–
Lift the ball handle
3
.
–
Turn the pedal platform
4
according to the working position and let
the ball handle
3
engage in the end position.
For all stand sets
–
Screw set point generator
5
to the stand.
–
Introduce the plug of the set point generator
5
into the bush
6
of
the control box.
–
Suspend the pedal rods
7
in the set point generator
5
.
–
Loosen slightly the clamping screw
8
.
–
Adjust the pedal rods so that the released pedal
1
has an
inclination of
about. 10°
.
–
Tighten the clamping screw.
6
5
8
7
2
1
3
4
10