Instruction manual

4.9 Error codes
EC10000 Acknowledging an error through the supervisor
EC20000 Check the thread tension, currently not in use
EC21000 Forced thread trimming in a tearing seam
EC21500 Received a wrong error message from the Efka
motor
EC21600 Received a wrong bobbin thread message
from
theEfkamotor
EC22000 Forced bartack in a t earing seam
EC22500 Wrong bartack in the seam
EC22600 Wrong stitch counting motor and PC
EC23000 Thread breakage in a tearing seam
EC23500 Thread tension too low in a tearing seam
EC23600 Thread tension too high in a tearing seam
EC25000 Thread breakage within a free seam
EC25500 Thread tension too low in a free seam
EC25600 Thread tension too high in a free seam
EC25700 Edge detection upper limit overran
EC25800 Edge detection lower limit overran
EC26000 Did not read the extra bar code label
(additional
bar code)
EC27000 Hardware-error, Efka control unit does not
react properly
EC27500 Hardware-error, Thread tension measuring
device
does not react properly
EC28000 Remained below the allowed stitch area
EC29000 Exceeded the allowed stitch area
EC31010 Incorrect reading of the final label bar code
EC31000 Incorrect reading of the final label bar code
with
the manual scanner of the supervisor
EC31500 Wrong final label sewn into the workpiece
EC32000 A bobbin with a non approved thread has been
inserted during the sewing process
EC33000 Bar code printer not ready
ECxxxxxACK The supervisor has acknowledged the error
“xxxxx”
ECxxxxxCNT The supervisor has released the further
processing
of the workpiece despite the error “xxxxx”
91