Instruction manual

1.3 Graduation on the handwheel

The handwheel 2 has a graduation printed on it.

Certain settings are carried out according to the position of the

handwheel.

–

Tur n the handwheel until the degree mark mentioned in the

present instructions points to the index 3.

–

Carry out the described adjustment.

Setting the handwheel

–

Set the handwheel to the degree mark 50°

–

Loosen the threaded pin for the handwheel through opening 1.

–

Set the handwheel to 0°

–

ArrestthemachineinpositionIIwiththelockingpinØ3mm

–

Loosen the threaded pin for the handwheel through opening 1.

–

Tur n the handwheel 2 so that the degree mark 0° points to the

middle of the index 3.

–

Tighten the threaded pin for the handwheel through opening 1.

–

Set the handwheel to 50° and tighten the threaded pin for the

handwheel.