Instruction manual

Read bobbin no. with Bobbin identification via
stat. scanner barcode (optional)
existing / not existing
With seam scanner Monitoring of the end label (optional)
existing / not existing
Cone switch for the Monitoring of the thread cone
needle thread via proximity switch.
The barcodes are read with the hand
scanner.
existing / not existing
Cone switch for the Monitoring of the thread
hook thread cone via proximity switch.
The barcodes are read with
the hand scanner.
existing / not existing
Multibarcodes Entering additional barcodes besides
the primary barcodes
possible / not possible
With UPS monitoring possible / not possible
Needle control Regular control / exchange of the
needle
activated / deactivated
Multibarcode switch Automatic entering of additional
barcodes with batch mode
activated / deactivated
Save individual stitch data of Saving the thread tension values
SAB-seam in a TXT-file
ON/OFF
Stitch counting with PC card The stitch counting of the PC
not of Efka is being considered
activated/ deactivated
Efka decorative bartack Make selection according to Efka
switched on parameter settings (decorative
bartack or regular bartack)
ON/OFF
Thread tens. individual Definition whether
stitch check the number of tolerance stitches in
a row should be outside of the
tolerance or be repartitioned over the
whole length
ON/OFF
Calibration control Regular checking of the step motor
and the thread tension sensor
ON/OFF
Thread tension graphic Visualization of the thread tension
during the sewing process
ON/OFF
72