Instruction manual

2.11.5 Cutting position

Standard checking

With the factory setting the cutting position corresponds to the

position “thread lever in its upper dead center” (65°on the handwheel).

–

Tur n the handwheel to position 0°.

–

Release the locking latch.

–

Swing out the thread-pulling knife 6 manually. In order to do so

push the lever 7 with the roller to the right against the control

cam 4.

–

Insert the thread into the thread-pulling knife 1.

–

Tur n the handwheel until the thread is cut.

–

Check whether the cutting took place in the position “thread lever

in its upper dead center” (65°on the handwheel).

Correction

–

Loosen the screws (2x) on the control cam 4.

–

Swing out the thread-pulling knife 1 until the blade of

thread-pulling knife 1 comes flush with the blade of the

counter-knife 2.

–

Bring the machine into the position “thread lever in its upper dead

center” (65°on the handwheel).

–

Shift the control cam 4 until its stops (against clamping ring 5) and

twist it on the shaft until the control cam 4 touches the roller 7.

–

Tighten the screws (2x) on the control cam 4 in this position again.

67 4