Instruction manual

2.9 Sewing foot lifting

2.9.1 Mechanical sewing foot lift

Caution: Risk of injury!

Tur n off the main switch.

Check and set the clearance of the lifting mechanism only when the

machine is switched off.

Standard checking

The lifting shaft 6 is supposed to run softly but should have no end

play. The clearance in the lifting mechanism should be approx. 0.5 mm

between the spring guide 2 and the lifting lever 1.

–

Lower the sewing feet.

–

Tur n the handwheel until the presser foot touches down.

–

Move the lifting shaft 6 and check its clearance.

Correction

Tightening the lifting shaft

–

Unscrew the electric and pneumatic unit 5.

–

Loosen the screw on the setting ring 3.

–

Push the lifting shaft 6 completely to the right (see the arrow),

push the adjustment ring 3 close to the bearing bush and tighten

it.

ATTENTION!

The shaft must still run softly.

Lifting shaft clearance

–

Loosen the screws on the lifter block 4.

–

Twist the lifting shaft 6 until it has the necessary clearance of 0.5

mm.

–

Tighten the screws on the lifter block 4.

12 1

54 3