Instruction manual

2.5.2 Needle penetration in feeding direction

Caution: Risk of injury!

Tur n off the main switch.

Check and set the needle penetration only when the machine is

switched off.

Standard checking

The needle is supposed to penetrate the center of the feed dog’s

stitch hole with the stitch length set to “0”.

–

Insert a new needle.

–

Set the stitch length to “0” by aligning the markings 4 and 5.

–

Tur n down the needle bar with the handwheel.

–

Check the position of the needle in the needle hole.

Correction

–

Loosen the screw 3 at the upper transmission lever.

–

Adjust the needle bar linkage 2 so that the needle 1 stands in the

center of the stitch hole.

–

Tighten screw 3 again.