Instruction manual

2.4 Transmission lever

Caution: Risk of injury!

Tur n off the main switch.

Check and set the transmission lever only when the machine is

switched off.

Standard checking

The lever 3 transmits the movement of the advance shaft to the needle

bar linkage.

The lever 3 must be positioned in a way the distance between the

surface of the arm 1 and the center of the bolt 2 amounts to 123,6 mm

with the stitch length set to “0”.

–

Set the stitch length to “0” by aligning the markings 6 and 7.

–

Check the distance between the top edge 1 and the bolt center 2.

Correction

–

Loosen the threaded pin 4 at the lower transmission lever.

–

Loosen the screw 5 at the upper transmission lever.

–

Adjust the lever 3 to fit the given measure.

–

Tighten the threaded pin 4 and the screw 5 again.

321